A2FIX - 333 (APPLY TO FIX)
FLEXIBLE POLYMER BASE ADHESIVE [C-2 Category]
A2FIX – 333 (APPLY TO FIX) is a water-resistant, fast-setting floor & wall adhesive, suitable for thin and thick-bed fixing in interiors and exteriors. Mixed with water, it is suitable for fixing ceramic floor and wall tiles, vitrified tiles and mosaics, brick slips and stone cladding.
ADVANTAGES
- Very good free flowing behavior.
- Very high bond & tensile strength.
- Easy to apply.
- Can be used in showers, swimming pools or under continuous immersion.
- For fixing ceramic floor and wall tiles
- Developed to deliver advanced fixing solutions.
AREAS OF APPLICATION
- Marbles, Glass tiles, Mosaic tiles.
- Swimming ploos
- Bathroom interior / exterior surfaces
- Tile on tile application for floor.
SUITABLE SUBSTRATES
- Stone, marble and brick.
- Cement plaster.
- Concrete and cement mortar bed.
- Cement sand screeds.
Precautions & Limitations
- Always add powder to liquid and not liquid to powder.
- While fixing tiles temperature must be between 5° C to 45°C. Always dampen the substrate & finish faster.
SURFACE PREPARATION
The surface should be properly leveled, sound, clean and free from dust, oil or grease & it should be in pre wet condition. All plumbing work should done before and placing bedding for tiling.
MIXING
Mix of approx. 3 parts powder to 1 part water by volume. Add the powder to clean water and mix thoroughly until a smooth uniform consistency is obtained.
CAUTION
Fast Bond A- 303 should NOT be used on painted, metal surfaces, ply & gypsum boards
GROUTING
Grouting can be carried out after a properly setting of tiles.
COVERAGE
Approximately 45-50 sq.ft per 20 kg.bag with ( 6mm X 6mm ) square notch trowel for a bed thickness of 3mm.
APPLICATION
- Spread the adhesive with a suitable notched trowel to cover approximately 1 m².
- Place and press the dry tiles firmly into the adhesive, checking periodically that good contact is maintained with the backs of the tiles.
- Remove all surplus adhesive with a damp cloth before it sets.
PACKING: 20KG
COLOR: Grey & White
TECHNICAL INFORMATION
- Appearance: Free flowing powder
- Color: White/Grey
- Bulk density, g/cc: 1.6
- Pot life @ 25°C, minutes: 60-90
- Open time, in minutes: 10-15
- Adjustability time, minutes: 10
- Trafficable time: 36 Hours
- Adhesion strength [Dry/wet.heat, freez-thaw] (EN1348, EN1324): >1.2 N/mm2
- Adhesive performance Category: C-2
- Mixing Ratio: 30-32% of powder
Get Free Quote
+91-8708217870
info@aerosealchem.com