J2-POXY GROUT
J2-POXY grout is use to seal joints and fill spaces between tiles, marble and stone used in the industrial floor, kitchen, bathroom, walls and floors. J2-Poxy is an Epoxy based, hard-wearing, impervious, high degree of resistance to chemical attack and waterproof. Two component, highly chemical and mechanical resistance, water cleanable epoxy grout for ceramic tiles, marbles and natural stones joints from 2 mm to 25 mm on flooring and walls.
ADVANTAGES
- Durable joints
- Stain resistant and waterproof
- High strength and hardness.
- Anti fungal and anti bacterial.
- Water cleanable and easy to apply
- Ideal for contact with aqueous food products
- Excellent adhesion to dry surfaces
- Hard wearing and impact resistant
- Good resistance to chemical attack
AREAS OF APPLICATION
- Industrial, kitchens, hospitals, wineries, breweries, food processing and soft drink factories and shower area.
- For areas requiring moderate chemical resistance.
SUITABLE SUBSTRATES
- Brick masonry and plaster surface
- Concrete and cement mortar bed.
- Cement sand screeds.
Precautions & Limitations
Recommended dosage should be applied to achieve desired results.
SURFACE PREPARATION
- All Joints must be free from dust.
- All Joints should be dry condition.
MIXING & APPLICATION
- EPOXY GROUT is a two part system. Contain Part-A (Resin) and Part B (Hardener). Mix Part-B into Part-A. Mix the whole until thoroughly until it be a forms uniform paste. (at low speed for 15 minutes).
- Do not apply when air or surface temperature below 5ºC.
- Do not add any modifiers.
- Use rubber floater or trowel to apply.
FINISHING
Clean the joints of floors and walls with the wet sponge before the product get hard. Joint must be washed with plenty of water and cleaned off with abrasive sponge. Remove the excess water with hard sponge. Use Tezxx Tez clean tile cleaner to remove any marks and stain.
Ready to use-Floor are ready for foot traffic after 24 hours at moderate temperature of +300C.
COVERAGE
Approximate ft2 coverage per 5 kg. unit for J2-PoxyGrout.
STORAGE & SHELF LIFE MATERIAL – 2 YEARS
- Store in a cool and dry place.
- Should store away from heat and sun light.
METHOD OF APPLICATION
- Trowel / Knife / Rubber Floater.
CLEAN UP & DISPOSAL
- Clean equipment and grout spatters with warm, soapy water.
HEALTH AND SAFETY CONDITIONS
- Should wear appropriate protective clothing, gloves, eye protection and respiratory protective equipment during application
- In case of contact with skin/eyes, wash with plenty of clean water and then rinse with soap water.
PACKING: 1KG, 5KG
TECHNICAL INFORMATION
- Pot life: 45 minutes
- Setting time: 6-8 hours (setting time can be very according to weather condition)
Get Free Quote
+91-8708217870
info@aerosealchem.com